Building - A Blood and Plunder Town.

A place of ill repute.

I've started to paint the few buildings I have printed for the 'Blood and Plunder' section of this project.

I went with a really fast technique and managed to get these 3 building to through these 3 simple stages in a couple of hours at most.

I first primed them all with a light grey primer in a regular rattle can.

After that I used Army Painter Leather Brown and Army Painter Dragon Red spray cans to do the wooden areas and roofs.

The red was actually an after-thought, I originally did all the roofs brown before realising I had red spray paint in the garage.

You don't need to be too neat with this process and a little overspray won't hurt.

Any areas with a lot of overspray just quickly tidy up a bit with light grey.

I then used a dark grey through an airbrush to mark out some darker areas.  around windows and doors etc.  Again, don't worry about being particularly careful.  Check out some of the images and you'll see I got spray everywhere in some cases.

Most of this will get covered up during the next step anyway.

Next, it's time to get out a big drybrush.

I used two successively lighter brown tones to quickly drybrush the woodwork and two light greys for the main parts of the building.

For the roofs a quick pale red followed by a more cream colour.

This helps blend in all the colours ready for the next step, which unfortunately may have to wait for a few weeks as I am about to be sent on a short deployment with work.

I dry-brushed the door and window frames to help them stand out a bit more from the walls.  For this I just used a really light grey followed by a light drybrush of off-white.

I then gave the entire building a quick coating or army painter quickshade.  This not only adds an extra level of grime that helped give that lived in look to buildings but also adds a nice protective varnish.

The shutters and doors were all undercoated with leather brown spray paint before being dry-brushed lighter shades of brown until the top highlight was almost white.

I then used various Games Workshop glazes over the doors and shutters to create a weathered painted wood look.  Finally, I picked out the metal studs on the doors with some chainmail paint.

I assembled all the doors and shutters using thin wire to allow them all to open and close before giving the entire model a coat of spray matt varnish.

The next stages will be to add some detailing and do the bases.